User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-4 Configuring Interface Information
Table 3-2 Interface Information Link Data Tab Parameters (Cont.)
Parameter Possible Values / Remarks
Routing / Bridging
(not available for
the SUB LINK or
CHANNEL)
Bridge, IP Router, IPX Router, IP and IPX Router, IP Brouter, IPX Brouter, IP and IPX
Brouter
IP Transparent
Mode
Enables/disables IP transparent mode. When this mode is enabled, all frames (including
broadcast and multicast frames) are forwarded from E1/T1 to LAN and from LAN to
E1/T1.
Disable
, Enable All
Note: This field is not available in the following cases:
• If any of the following interfaces exists on the device:
LINK 3; LAN 2; ISDN; or a non-Channel
X.21(4), V.24(11), RS-530(3), or DB-25(17)
• When the value in the Routing/Bridging field is one of the following:
Bridge, IPX Router, IPX Brouter
When the selected interface is a Channel
IP Transparent
Default Gateway
Specifies the default Gateway IP address used for transparent IP.
Configuring SHDSL Interface Information
This section describes how to view and configure SHDSL interface information.

To configure interface information:
1. Select an SHDSL Link.
The Agent view is displayed for the selected link.
2. Select Configuration > Interface Info…
The Interface Information dialog box appears. There are two tabs: Info and
Link Data.
Link Data tab is disabled for Sub and Voice links.
3. Click on the required tab.
4. Configure the desired parameters.
5. Click <Set>.
Note