User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Interface Information 3-3
Figure 3-2. Interface Information Link Data Tab
• Link Data tab is disabled for Sub and Voice links.
• Changing the protocol type from Frame Relay (RFC 1490) to any other protocol
will cause the device to reset.
The following message appears “This operation will cause HW reset of the
Device. Continue?”
Click <OK> to confirm reset.
Table 3-2. Interface Information Link Data Tab Parameters
Parameter Possible Values / Remarks
Interface The selected interface.
State Enable, Disable, Backup (only if there is more than one link)
Backup of Link The combo box listing links in current configuration.
Note: This field is disabled for SUB links
Link Type
Synchronous
,
Asynchronous (only for V.24 connector)
Protocol Type
(not available for
the SUB LINK or
CHANNEL)
Slip, Cslip, PPP
, HDLC Framing, RFC 1490
Notes