User`s manual

Table of Contents
ii RADview FCD-IP User’s Manual
3.4 Configuring Protocol Parameters................................................................................ 3-29
Configuring Frame Relay Protocol Parameters .....................................................................3-29
Configuring the DLCI Table.................................................................................................3-30
Configuring PPP Parameters................................................................................................3-32
3.5 Configuring Network Parameters ............................................................................... 3-34
Configuring IP Addresses.....................................................................................................3-34
Configuring the IP Routing Protocol ....................................................................................3-35
Configuring the IP RIP Mode...............................................................................................3-36
Configuring DHCP Relay.....................................................................................................3-37
3.6 Resetting the Link ...................................................................................................... 3-37
3.7 Performing Diagnostic Tests ....................................................................................... 3-38
Chapter 4. Fault Management
4.1 Edit and Agent Views ................................................................................................... 4-1
4.2 Displaying Sanity Check Errors (E1/T1 Link) ................................................................. 4-1
4.3 Displaying SHDSL Alarms ............................................................................................ 4-2
Chapter 5. Performance
5.1 Edit and Agent Views ................................................................................................... 5-1
5.2 Setting the Polling Interval............................................................................................ 5-2
5.3 Performing Diagnostic Tests ......................................................................................... 5-2
5.4 Displaying E1/T1 Statistics............................................................................................ 5-3
Packets Data Statistics ...........................................................................................................5-3
Packets Graph Statistics.........................................................................................................5-4
Physical Layer Statistics .........................................................................................................5-6
Protocol Layer Statistics.........................................................................................................5-9
5.5 Displaying E1 Over SHDSL Statistics .......................................................................... 5-12
Physical Layer Statistics .......................................................................................................5-12
5.6 Displaying Ethernet LAN Statistics .............................................................................. 5-15
Chapter 6. Configuring FCD-IP for a Typical Application
6.1 Overview..................................................................................................................... 6-1
Application ...........................................................................................................................6-1
6.2 Configuring WAN Parameters ...................................................................................... 6-2
Configuring the WAN Interface .............................................................................................6-2
Configuring the WAN IP Address ..........................................................................................6-3
6.3 Configuring the E1 Interface......................................................................................... 6-4
Configuring E1 Parameters ....................................................................................................6-4
Mapping E1Timeslots............................................................................................................6-5
6.4 Configuring the LAN Interface...................................................................................... 6-5
Enabling the LAN..................................................................................................................6-5
Configuring the LAN IP Address ............................................................................................6-6
Configuring Default Gateway Settings....................................................................................6-7