User`s manual

Configuring Interface Information 3-1

Chapter 3

Port Management

This chapter describes RADview’s configuration and operation procedures for the

FCD-IP LINK and LAN. The LINK or LAN Level is available when a LINK or LAN is

selected. Some LINKS have both edit and agent levels. This chapter details the

different management options for each LINK and LAN separately.

3.1 Edit and Agent Views

Certain TDM ports can be displayed in both Edit and Agent Views. Configuration is

performed in the Edit mode. In Agent View, the parameters are Read-Only.



To switch between Edit and Agent views:

1. Select the appropriate interface.

The Agent view is displayed for the selected link.

2. Switch to Edit View by doing one of the following:

 Click the Edit/Agent View button on the toolbar

 Select Window > Edit View/Agent View to switch to Edit/Agent View.

3.2 Configuring Interface Information

This section describes how to view and configure interface information.

For information on configuring physical port parameters, see Configuring Physical

Parameters.

Configuring E1/T1, CHANNEL, ISDN, and Voice Interface Information

This section describes how to view and configure E1/T1, CHANNEL (V.24, V.35),

ISDN and Voice (FXS, FXO and E&M) interface information. The parameters of the

Interface Information dialog boxes differ depending on the selected interface.

• For information on E1/T1 over SHDSL, see Configuring E1/T1 over SHDSL

Interface Information.

• Voice interface configuration can be performed in both Agent and Edit Views.

Note

Notes