User`s manual

Chapter 2 System Management RADview FCD-IP User’s Manual
2-20 Configuring the Dynamic Host Configuration Protocol (DHCP)
Table 2-13. Dynamic Host Configuration Protocol Parameters (Cont.)
Parameter Possible Values / Remarks
Interface The interface through which the remote interface of the IP address is received.
All, LAN1
, LAN2, Any LAN, WAN
[Apply] To save changes in table, click <Apply>.
[Add…] To add an entry to the table, click <Add…>. Configure the parameters in the Add
DHCP Entry table and click <Set>. A maximimum of 10 entries is allowed in the
table.
[Change…] To change an entry, select it and click <Change…>.
Make desired changes in Change DHCP Entry table and click <Set>.
[Remove] To delete an entry, select it and click <Remove>.

To add an DHCP entry:
1. In the DHCP Table, click <Add…>.
The Add DHCP Entry dialog box appears.
Figure 2-20. Add DHCP Entry
2. Configure desired parameters (see Table 2-13).
3. Click <Set>.
The Add DHCP Entry dialog box closes.

To change a DHCP entry:
1. In the DHCP Table, click <Change…>.
The Change DHCP dialog box appears.