User`s manual

Chapter 2 System Management RADview FCD-IP User’s Manual
2-14 OSPF

To add an Area Aggregation entry:
1. In the Area Aggregation Table, click <Add…>.
The Add Area Aggregation dialog box appears.
Figure 2-14. Add Area Aggregation
2. Configure desired parameters (see Table 2-8).
3. Click <Apply>.
(Clicking <Apply> performs Set operation without closing dialog box.)
4. When all entries have been added, click <Close>.
The Add Area Aggregation dialog box closes and all added entries appear
at the end of the list.

To enable/disable Advertising for an area aggregation:
1. In the Area Aggregation Table, click <Change…>.
The Change Area Aggregation dialog box appears. This dialog is the same
as the Add Area Aggregation dialog box, except that the only parameter
that can be changed is Advertised.
2. Select Yes or No for the Advertised parameter and click <Set>.
OSPF Information
RADview enables you to view information regarding the following categories:
• Interfaces
• Neighbors
• Database.