User`s manual

RADview FCD-IP User’s Manual Chapter 2 System Management
OSPF 2-11

To disable OSPF:
1. Select Configuration > OSPF > Parameters….
The OSPF Parameters dialog box appears.
Figure 2-11. OSPF Parameters (Disable)
2. In the Admin Status field, select Disable.
3. Click <Set> to implement the changes.
The following confirmation message appears:
“This operation will cause Restart of the device /n Connection with Agent
will be lost.”
4. Click <OK>.
Table 2-6. OSPF Parameters
Parameter Possible Values / Remarks
Admin Status Enable/Disable
Router ID The IP address format.
Required if OSPF is enabled.
Not available is OSPF is disabled.
Redistribute Routers Enable/Disable
Not available is OSPF is disabled.