User`s manual

RADview FCD-IP User’s Manual Chapter 2 System Management
Routing the IP 2-9

To add an IP address:
1. In the IP Address Table (Figure 2-7), click <Add…>.
The Add IP Address dialog box appears (Figure 2-8).
Figure 2-8. Add IP Address
When working in OSPF mode, each LAN can have only one IP address.
2. Configure desired parameters (see Table 2-3).
3. Click <Set>.

To change an IP address:
1. In the IP Address Table (Figure 2-7), click <Change…>.
The Change IP Address dialog box appears (Figure 2-9).
Figure 2-9. Change IP Address
2. Configure desired parameters (see Table 2-3).
3. Click <Set>.
Note