User`s manual

RADview FCD-IP User’s Manual Chapter 1 Introduction
LEDs 1-3
1.4 Edit and Agent Views
Certain TDM ports can be displayed in both Edit and Agent Views. Configuration is
performed in the Edit mode. In Agent View, the parameters are Read-Only.

To switch between Edit and Agent views:
1. Select the appropriate Link.
2. Switch the view by doing one of the following:
 Click the Edit/Agent View button on the toolbar
or
 From the Window menu, select Edit View/Agent View to switch to
Edit/Agent View.
3. When entering Edit View, you must enter the password.
Type the password in the field provided and click <Set>.
Figure 1-2. Password Dialog
1.5 LEDs
Table 1-1 describes the device LEDs.
Table 1-1. FCD-IP LEDs
Object Description Function
PWR Green LED ON when the device is powered on.
READY Green LED ON when the packets can be transferred.
LAN1 DATA
LAN2 DATA
Yellow LED ON when a packet is received or transmitted on the LAN side.
LAN1 ERR
LAN2 ERR
Red LED ON when a LAN interface indicates an error.
LINK 1 DATA
LINK 2 DATA
Yellow LED Turns ON briefly when a packet is received or transmitted on the
LINK side.
Blinks constantly to show ISDN link integrity.
Note