User`s manual

RADview FCD-IP User’s Manual Chapter 6 Configuring FCD-IP for a Typical Application
Configuring the LAN Interface 6-7
3. In the IP Addresses Table, click <Add…>.
The Add IP Address dialog box appears.
Figure 6-9. Add IP Address
4. In the IP Address field, type 192.168.10.2.
5. In the IP Mask field, type 255.255.255.000.
6. In the Interface drop-down list, select LAN1.
7. Click <Add>.
Configuring Default Gateway Settings

To configure default gateway settings:
1. Select Configuration > System Commands > DHCP…
The DHCP table appears (Figure 6-10).
Figure 6-10. Dynamic Host Configuration Protocol Table
2. Click <Add…>.
The Add DHCP Entry table appears.