User`s manual

Chapter 6 Configuring FCD-IP for a Typical Application RADview FCD-IP User’s Manual
6-4 Configuring the E1 Interface
4. In the IP Address field, type 192.168.10.1.
5. In the IP Mask field, type 255.255.255.252.
6. In the Interface drop-down list, select LINK1.
7. Click <Set>.
6.3 Configuring the E1 Interface
Configuring the E1 interface includes the following:
• Configuring E1 Parameters
• Mapping E1 Timeslots.
Configuring E1 Parameters

To configure E1 parameters:
1. Select LINK1.
2. Switch to Edit View: Click the Edit View button on the toolbar
.
3. Select Configuration > Physical Parameters > General….
The E1 Link Parameters dialog box appears.
Figure 6-5. The E1 Link Parameters
4. From the Clock Source drop-down list, select Link 1.
5. From the Multiplier drop-down list, select 64 kbps.
6. Click <Set>.