User`s manual

RADview FCD-IP User’s Manual Chapter 6 Configuring FCD-IP for a Typical Application
Configuring WAN Parameters 6-3
5. From the State drop-down list, select Enable.
6. In the Link Type field, type Synchronous.
7. From the Protocol drop-down list, select PPP.
8. From the Routing/Bridging drop-down list, select IP Router.
9. Click <Set>.
Configuring the WAN IP Address

To configure the WAN IP address:
1. Switch to Agent View: Click the Agent View button on the toolbar
.
2. Select Configuration > Network Parameters > IP Address....
The IP Address Table appears (Figure 6-3).
Figure 6-3. IP Addresses Table
3. In the IP Address Table (Figure 6-3), click <Add…>.
The Add IP Address dialog box appears (Figure 6-4).
Figure 6-4. Add IP Address