Specifications

Appendix B Installing New Software Releases Installation and Operation Manual
B-2 Downloading the Software File MiTOP-E1/T1 Ver. 1.0
7. Select the Settings tab and under Emulation, choose VT100, and then click
OK.
The COM port configuration is complete, and the HyperTerminal
connection is ready for use.
8. Close the HyperTerminal application.
B.2 Downloading the Software File
You can upgrade the MiTOP-E1/T1 device’s software by downloading software via
SFP-CA. The HyperTerminal application is used for the software download.
³ To upgrade the MiTOP-E1/T1 software:
1. Verify that the upgrade image file provided is accessible from your PC.
2. Configure MiTOP-E1/T1 to the SW Download mode (see
Chapter 2 )
3. If the SFP-CA unit is not connected to your PC, connect power to SFP-CA and
plug the USB connector of SFP-CA into a USB port on your PC.
4. Plug the miniature device into the SFP socket on the SFP-CA unit.
5. Open the HyperTerminal application and load the HyperTerminal connection
that you established previously (see
Establishing a HyperTerminal Connection
above).
The first screen appears indicating that the system is ready for
downloading.
============================================================
= (C) RAD Data Communication =
= =
= Software Download ( version 1.0d02) =
= =
= =
============================================================
1 – Download an application by YMODEM
If you plug MiTOP-E1/T1 into SFP-CA before connecting the configuration unit to
the PC, the upper section of the Download screen is not displayed; only the
Download an Application by YMODEM option is visible.
1. Select Download an Application by YMODEM to start the procedure.
A warning appears indicating that the flash will be corrupted.
2. Press y to confirm.
Sectors are erased and the Send File screen appears, prompting you to
specify the name and the location of the upgrade image file.
Note