Specifications

MiTOP-E1/T1 Ver. 1.0 Establishing a HyperTerminal Connection B-1
Appendix B
Installing New Software
Releases
This appendix presents procedures for downloading software to MiTOP-E1/T1.
New software releases are downloaded to MiTOP-E1/T1 via the SFP-CA
configuration unit.
B.1 Establishing a HyperTerminal Connection
Upgrading MiTOP-E1/T1 requires a PC with Windows XP SP2 installed and
equipped with at least one USB port. The required HyperTerminal application is
pre-installed.
Do not connect the MiTOP-E1/T1 device to SFP-CA during this procedure.
³ To establish a HyperTerminal connection:
1. If the SFP-CA unit is not connected to your PC, connect power to SFP-CA and
plug the USB connector of SFP-CA into a USB port on your PC.
2. Open the HyperTerminal application.
The Connection Description dialog box for a new connection appears.
3. Specify a name for the HyperTerminal connection, and click OK.
The Connect To dialog box appears.
4. Choose a virtual COM port, for example COM8, and click OK.
The COM Properties dialog box appears.
5. Specify the settings as listed below and then click OK.
 Bits Per Second: 115200
 Data Bits: 8
 Parity: None
 Stop Bits: 1
 Flow Control: None
6. Click Properties.
The Connection Properties dialog box appears.
Note