Specifications

Installation and Operation Manual Chapter 5 Configuring a Typical Application
MiTOP-E1/T1 Ver. 1.0 Configuring Gmux-2000 5-9
Pseudowire Gateway
Config>Physical layer>E1 port - (IO 1: EXT PORT 1 CARD TYPE- CES E1)
1. Channel ID[1 - 28] ... (1)
2. Admin Status (Connected)
3. Idle code[0 - ff] ... (7E)
4. OOS Signaling > (Space)
5. OOS code[0 - ff] ... (FF)
6. Transmit clk source > (System a)
7. Rx Sensitivity > (Short Haul)
8. Bundle number[1 - 2000] ... (0)
9. TS type (NC)
10. Line type > (Framed G.704 CRC)
11. Restoration Time > (CCITT)
Figure 5-13. Configuring the Physical Layer of the Gmux-200 External E1 Port
Configuring the Bundle
A bundle is a pseudowire connection to be attached to the MiTOP-E1/T1 PW to
complete the communication link.
³ To configure the bundle:
1. From the Connection menu (Config>Connection), type X to add a new bundle.
2. Set the new bundle connection mode to CES and PSN type to UDP/IP.
Config>Connection
1. Bundle ID[1 - 2000] ... (1)
2. Connection mode > (CES)
3. PSN type (UDP/IP)
4. Connection configuration []>
5. Save parameters
Figure 5-14. Selecting Connection Mode and PSN Type for Gmux-2000
3. From the Connection Configuration menu (Config > Connection > Connection
configuration), set:
 Connection State: Enable
 Source CBID: 16
 Dest CBID: 15
 TDM frame in packet: 8
 OAM Connectivity: Disable
 Far end type: E1
 Destination IP: 10.10.10.2
 Network slot port: 6/1.