Specifications

Installation and Operation Manual Chapter 5 Configuring a Typical Application
MiTOP-E1/T1 Ver. 1.0 Configuring MiTOP-E1/T1 5-3
³ To configure the physical layer of the E1 interface:
• From the E1 menu (Configuration > Physical Ports > E1), set:
 TX Clock Source: Adaptive
 Line Type: G.732N CRC.
MiTOP-E1/T1
Configuration > Physical Ports > E1
Tx Clock Source Adaptive
Line Code HDB3
RX Sensitivity Short Haul
Line Type G.732N CRC
Figure 5-3. Configuring the Physical Layer of the E1 Interface
Defining a Pseudowire Peer
Gmux-2000 serves as a peer device for MiTOP-E1/T1.
³ To define the pseudowire peer:
• From the Peer menu (Configuration > Applications
> Multiservice over PSN >
Peer), set:
 Peer IP Address: 10.10.10.5
 Peer MAC Address: 01-d3-10-fe-32-2a
MiTOP-E1/T1
Configuration > Applications > Multiservice over PSN > Peer
Peer Number 1
Peer Name Peer Name 1
Peer IP Address 10.10.10.5
Next Hop 10.10.10.5
Peer MAC Address 01-d3-10-fe-32-2a
Peer Number Peer Name Peer IP Address Next Hop Address Peer MAC Address
1 Peer Name 1 10.10.10.5 10.10.10.5 01-d3-10-fe-32-2a
Figure 5-4. Defining the Peer