Specifications

Chapter 5 Configuring a Typical Application Installation and Operation Manual
5-2 Configuring MiTOP-E1/T1 MiTOP-E1/T1 Ver. 1.0
2. Configuring ETX-550:
a. Setting the management parameters (host IP, network manager)
b. Configuring the bridge mode.
3. Configuring Gmux-2000:
a. Loading and verifying the hardware configuration
b. Setting the management parameters (host IP, network manager)
c. Selecting a system clock
d. Configuring the E1 interface at the physical level
e. Configuring the bundle
f. Connecting the E1 port to the bundle.
5.2 Configuring MiTOP-E1/T1
MiTOP-E1/T1, installed in the ETX-550 Ethernet aggregator, packetizes and
encapsulates the E1 TDM traffic to be carried over the UPD/IP network to
Gmux-2000.
Configuring the Host IP Parameters
The host IP address serves as a destination of the management traffic. The
default host IP address is 192.168.205.1.
³ To configure the host IP parameters:
• In the IP Address field of the Host IP menu (Configuration > System >
Management > Host IP), enter the new host IP address – 10.10.10.1.
MiTOP-E1/T1
Configuration > System > Management > Host IP
IP Address 10.10.10.1
IP Mask 0.0.0.0
Default Gateway 0.0.0.0
Host Tagging Untagged
Figure 5-2. Configuring the Host IP Address
Configuring the E1 Interface at the Physical Level
Before creating a pseudowire connection, configure the physical layer parameters
of the E1 TDM interface.