Specifications

Installation and Operation Manual Chapter 4 Configuration
MiTOP-E1/T1 Ver. 1.0 Additional Tasks 4-19
Displaying the PW Connection Status
You can view the status of the PW connection at the physical level.
³ To display the PW connection status information:
• From the Physical Layer menu (Monitoring > Physical Layer), select
Connections Status.
The Connection Status screen is displayed.
The Connection Status parameters are described below.
 Destination IP address – IP address of the destination device
MiTOP-E1/T1
Monitoring > Physical Layer > Connection Status
Destination IP Address 0.0.0.0
Next hop MAC Address 00-00-00-00-00-00
Connectivity Status Out of Sync
HW Lack of Tx Buffers No
Packet Length Error No
Rx Sync Loss Yes
Rx Remote Fail Yes
Rx Lbit Modifier 2
Rx Length Mismatch Discard No
Figure 4-21. Connection Status Screen
Table
4-5. Connection Status Parameters
Parameter Description
Destination IP Address IP address of the destination device
Next Hop MAC Address MAC address of the next hop device
Connectivity Status Status of the OAM connection:
• Out of sync
• Not valid
• Sync
Packet Length Error Packet discarded due to mismatch between IP length or control word length
and actual length
Rx Sync Loss Received packet with “L” indication
Rx Remote Fail Received packet with “R” indication
Rx Lbit Modifier Received packet with “M” indication
Rx Length Mismatch Discard Packet discarded due to mismatch between the configured and actual
packet length