Specifications

Chapter 4 Configuration Installation and Operation Manual
4-14 Configuring MiTOP-E1/T1 for Operation MiTOP-E1/T1 Ver. 1.0
Parameter Function Values
OAM Controls OAM functionality required for correct
communication with SFP-CA device. Always enable the
OAM when operating MiTOP-E1/T1 with SFP-CA.
Enable – OAM is enabled
Disable – OAM is disabled
Default: Enable
Unreachable
Detection
Defines whether MiTOP-E1/T1 recognizes or ignores
the Unreachable Destination (ICMP type 3) packets
Enable – MiTOP-E1/T1 suspends
PW operation for one minute
when an Unreachable
Destination (ICMP type 3) packet
is received
Disable – MiTOP-E1/T1 ignores
Unreachable Destination packets
Default: Disable
Multiplexing Defines the UDP source and destination ports Source – UDP destination port is
0x085E, and UDP source port is
0xC0000000 + Out PW label
Destination – UDP destination
port is 0xC0000000 + Out PW
label, UDP source port is
0xC0000000 + In PW label
Default: Source
Out PW Label Defines the outgoing (egress) PW label 1–8063
Default: 16
In PW Label Defines the incoming (ingress) PW label 1–127
Default: 16
MiTOP-E1/T1
Configuration > Applications > Multiservice over PSN > PW > PSN
Parameters
PW Number 1
PW Name PW Name 1
PW Type CESoPSN
PW Reordering Enable
ToS [0-255] 0
VLAN Tagging Enable
VLAN Priority [0-7] 0
VLAN ID [1-4095] 1
Figure 4-16. PSN Parameters Menu (UDP/IP Network)