Specifications

Installation and Operation Manual Chapter 4 Configuration
MiTOP-E1/T1 Ver. 1.0 Configuring MiTOP-E1/T1 for Operation 4-13
MiTOP-E1/T1
Configuration > Applications > Multiservice over PSN > PW > General
Parameters
PW Number 1
PW Name PW Name 1
PW Type CESoPSN
Source IP 0.0.0.0
PSN Type UDP/IPv4
Peer Number 1
Owner Manually
OAM Enable
Unreachable Detection Disable
Multiplexing
Source
Out PW Label [1-8063] 16
In PW Label [1-127] 16
Figure 4-15. General Parameters Menu (CESoPSN PW, UDP/IPv4 Network)
Table
4-2. General Parameters
Parameter Function Values
PW Number Number of pseudowire connection 1
Default: 1
PW Name User-defined name of the PW. This parameter is
configured via the PW menu (
Figure 4-14 ).
Default: PW Name 1
PW Type Defines encapsulation type used for PW creation. CESoPSN for framed E1/T1 service
SAToP for unframed E1/T1 service
Default: CESoPSN
Source IP Defines the IP source address of the PW 0.0.0.0 to 255.255.255.255
Default: 0.0.0.0
PSN Type Defines the packet-switched network type. The PSN
settings are configured via the PSN Parameters menu
(see
Figure 4-16 ).
UDP/IPv4, MPLS, MEF
Default: UDP/IPv4
Peer Number Specifies the name of peer, which terminates the PW 1
Default: 1
Owner Determines whether the PW is established manually
or by LDP signaling. Currently, it is permanently set to
Manually.