Specifications

Chapter 4 Configuration Installation and Operation Manual
4-12 Configuring MiTOP-E1/T1 for Operation MiTOP-E1/T1 Ver. 1.0
MiTOP-E1/T1
Configuration > Applications > Multiservice over PSN > PW
PW Number 1
PW Name PW Name 1
Connection Status Enable
Discarded by 15
General Parameters
PW Parameters
Service Parameters
Figure 4-14. PW Menu
Table
4-1. PW Parameters
Parameter Function Values
PW Number Number of pseudowire connection 1
Default: 1
PW Name User-defined name of the PW. Default: PW Name 1
Discarded by Defines the method for counting packets discarded on the
pseudowire connection.
The parameter value is binary, holding four bits. Each bit
represents a different counter. Setting a bit to 1 enables the
counter, and setting the bit to 0 disables it.
• Counter [3] counts packets that were discarded because of
jump operation that caused overflow in jitter buffer.
• Counter [2] counts packets that were discarded due to
incorrect sequence number.
• Counter [1] counts packets that were discarded due to
over-run state in jitter buffer.
• Counter [0] counts packets that were discarded because
they were considered duplicated, or because they were
received too late to be inserted into the jitter buffer
For example, to enable counters 3 and 1, set bits 3 and 1 to
Enable. The value to be entered is 1 (1010b).
0–15
Default: 15