Specifications

Installation and Operation Manual Chapter 4 Configuration
MiTOP-E1/T1 Ver. 1.0 Configuring MiTOP-E1/T1 for Operation 4-11
When the changes are saved, MiTOP-E1/T1 displays the peer configuration
summary.
MiTOP-E1/T1
Configuration > Applications > Multiservice over PSN > Peer
Peer Number 1
Peer Name Peer Name 1
Peer IP Address 00.00.00.00
Next Hop 00.00.00.00
Peer MAC Address 000000000000
Peer Number Peer Name Peer IP Address Next Hop Address Peer MAC Address
1 Peer Name 1 00.00.00.00 00.00.00.00 00-00-00-00-00-00
Figure 4-13. Peer Menu
Defining a Pseudowire Connection
For each pseudowire connection it is necessary to configure its general, PSN and
service parameters. MiTOP-E1/T1 supports CESoPSN and SAToP payload
encapsulation. PW connections can be established over MPLS, UDP/IPv4 or
Ethernet (MEF) networks.
³ To define a PW:
1. From the PW menu (Configuration > Applications > Multiservice over PSN >
PW), configure the initial PW parameters (see
Figure 4-14 and Table 4-1 ).
2. Configure the general parameters of the PW (see
Figure 4-15 and Table 4-2 ).
3. Configure the PSN parameters of the PW (see
Figure 4-16 and Table 4-3 ).
4. Configure the service parameters of the PW (see
Figure 4-17 and Table 4-4 ).
5. Verify that the PW connection status is enabled. The status remains enabled
only when valid values are defined for:
 Peer IP Address (Configuration > Applications > Multiservice over PSN >
Peer)
 Source IP (Configuration > Applications > Multiservice over PSN > PW >
General Parameters).
6. Save the changes.
7. Select View PW from the Multiservice over PSN menu to display the
configuration summary of the PW connection.