Specifications

Chapter 4 Configuration Installation and Operation Manual
4-10 Configuring MiTOP-E1/T1 for Operation MiTOP-E1/T1 Ver. 1.0
Defining the Adaptive Clock Quality
When the Rx clock source of a TDM interface is set Adaptive, it is necessary to
define the adaptive clock quality.
³ To define the adaptive clock quality:
• From the Clock Recovery menu (Configuration > System > Clock Recovery),
select the quality of the adaptive clock source: Stratum 1, Stratum 2,
Stratum 3, Stratum 3E or Stratum 4.
Clock mode is permanently set to Auto.
MiTOP-E1/T1
Configuration > System > Clock Recovery
Source Quality Stratum 1
Clock Mode Auto
Figure 4-12. Clock Recovery Menu
Configuring Multiservice over PSN Application
MiTOP-E1/T1 units communicate with peer devices via pseudowire (PW)
connections that are established over the packet-switched network.
Use the following procedure to create PW connections over the packet-switched
network:
1. Define a MiTOP-E1/T1 peer device.
2. Create a pseudowire connection (PW), and configure its general, network and
service parameters.
Defining a Peer
A peer is a device which communicates with MiTOP-E1/T1 over a PW connection.
³ To define a peer:
• From the Peer menu (Configuration > Applications
> Multiservice over PSN >
Peer), perform the following:
 In the Peer Number field, enter the number of the peer to be added.
Currently MiTOP-E1/T1 supports a single peer device, with Peer Number
permanently set to 1.
 In the Peer Name field, enter a description of the peer.
 In the Peer IP Address field, enter an IP address of the peer device.
 In the Next Hop field, enter the next hop address of the peer device.
 In the Peer MAC Address field, enter a MAC address of the peer device.
Note