Specifications

Installation and Operation Manual Chapter 4 Configuration
MiTOP-E1/T1 Ver. 1.0 Configuring MiTOP-E1/T1 for Operation 4-7
2. Specify MiTOP-E1/T1 LOS behavior.
 LOS:
 Enable (LOS on the TDM link is propagated as LOS to the Ethernet
interface)
 Disable (LOS on the TDM link is not propagated as LOS to the
Ethernet interface)
 RDI:
 Enable (RDI on the TDM link is propagated as LOS to the Ethernet
interface)
 Disable (LOS on the TDM link is not propagated as LOS to the
Ethernet interface)
 AIS:
 Enable (AIS on the TDM link is propagated as LOS to the Ethernet
interface)
 Disable (AIS on the TDM link is not propagated as LOS to the Ethernet
interface)
If the line code is set to AMI, the LOS Behavior screen is inactive, although it is
accessible and all parameters are displayed.
Configuring TDM Ports at the Physical Level
MiTOP-E1/T1 has one 100BaseFx and one E1/T1 TDM port. Before defining
pseudowire connections, select the TDM port type and configure it at the physical
level.
Selecting the TDM Interface Type
Before configuring the MiTOP-E1/T1 TDM interface, it is necessary to select its
type (E1 or T1).
³ To select the TDM interface type:
• From the Physical Ports menu (Configuration > Physical Ports), choose the
type of the MiTOP-E1/T1 TDM link (E1 or T1).
MiTOP-E1/T1
Configuration > Physical Ports
Ethernet
E1
Interface Type E1
Figure 4-9. Physical Ports Menu
Note