Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring MiTOP-E1/T1 for Operation MiTOP-E1/T1 Ver. 1.0
Enabling/Disabling I
2
C Cycle Stretching
MiTOP-E1/T1 can be configured to operate with or without the I
2
C cycle
stretching functionality. Refer to
Appendix C for additional information.
³ To enable or disable I
2
C cycle stretching:
• From the Outband menu (Configuration > System > Management > Outband),
perform the following:
 To enable I
2
C cycle stretching, select Normal.
 To disable I
2
C cycle stretching, select Without Stretching.
MiTOP-E1/T1
Configuration > System > Management > Outband
Outband Mode Normal
Outband Address 128
Figure 4-5. Outband Menu
4.2 Configuring MiTOP-E1/T1 for Operation
The recommended configuration procedure for MiTOP-E1/T1 includes the
following stages:
1. Configuring device-level parameters
2. Configuring the TDM interfaces at the physical level
3. Configuring the multiservice over PSN application (pseudowire and network
parameters).
Configuring the System-Level Parameters
The system-level parameters of MiTOP-E1/T1 include the following:
• Fault propagation
• Tx disable mode
• LOS behavior.
These parameters are configured via the System menu.