Specifications

Chapter 3 Operation Installation and Operation Manual
3-4 Configuration Alternatives MiTOP-E1/T1 Ver. 1.0
Type Parameter Default Value
Diagnostics
Loopback State Disable
Loop Timeout 0
TRDI Disable
TAIS Disable
3.3 Configuration Alternatives
If required, MiTOP-E1/T1 can be reconfigured, using different ports and
applications:
• Local out-of-band management via an I
2
C interface
• Local or remote inband management via a Fast Ethernet port, using RAD’s
Web-based application.
Working with the I
2
C Interface
MiTOP-E1/T1 allows monitoring a current status and performing diagnostics via
the SFP edge connector’s I
2
C interface. Refer to Appendix C for instructions and
the required message format.
Working with the Web Browser
You can locally or remotely configure and manage MiTOP-E1/T1 using a
Web-based management interface.
Chapter 4 illustrates menus and explains
configuration parameters.
Web Browser Requirements
The following Web browsers can be used to access the MiTOP-E1/T1 supervision
utility from any location that enables access to the MiTOP-E1/T1 using Internet
protocols.
• Internet Explorer 6.0 and up, running on Windows™
• Netscape Communicator 7.0 and up, running on Windows™, HPOV or Linux
• Firefox 1.0.4 and up, running on Windows™
• Mozilla 1.4.3 and up, running on Linux.
However, before using Web access, it is necessary to perform a preliminary
configuration of MiTOP-E1/T1.
When using a Web browser, pay attention to the following points:
• Enable scripts
• Configure the firewall that is probably installed on your PC in order to allow
access to the destination IP address