Specifications

Installation and Operation Manual Chapter 2 Installation and Setup
MiTOP-E1/T1 Ver. 1.0 Installing MiTOP-E1/T1 in the Host Unit 2-3
Figure
2-2. SFP-CA Configuration Unit
³ To eject MiTOP-E1/T1 from SFP-CA:
1. Close all relevant management applications.
2. Push the release button at the front of MiTOP-E1/T1 to disconnect it from
SFP-CA.
3. Remove MiTOP-E1/T1 from the SFP socket on SFP-CA.
2.6 Installing MiTOP-E1/T1 in the Host Unit
You do not have to switch off the host unit when inserting or extracting
MiTOP-E1/T1.
³ To insert MiTOP-E1/T1:
1. Configure MiTOP-E1/T1 to the normal operation mode.
2. Insert MiTOP-E1/T1 into a free SFP (MSA-compatible) socket of the host
equipment.
3. Press MiTOP-E1/T1 firmly into the MSA SFP port connector.
MiTOP-E1/T1 is ready to operate.
³ To eject MiTOP-E1/T1:
1. Disconnect cables attached to MiTOP-E1/T1.
2. Push the release button at the front of MiTOP-E1/T1 to extract it from the
edge connector.
3. Remove MiTOP-E1/T1 from the socket.
Note