Specifications

Quick Start Guide Installation and Operation Manual
2 Configuring MiTOP-E1/T1 MiTOP-E1/T1 Ver. 1.0
Connecting the Interfaces
• Connect MiTOP-E1/T1 to the E1/T1 devices using standard straight E1/T1
cables.
2. Configuring MiTOP-E1/T1
Configure MiTOP-E1/T1 to the desired operation mode, using a Web-based
management application. The device is accessed via its LAN port.
Configuring E1 and T1 at the Physical Level
E1 and T1 interfaces must be configured at the physical level first.
³ To configure E1 and T1 at the physical level:
1. From the TDM Interface Type menu (Configuration > Physical Ports, select the
TDM interface type, E1 or T1.
2. From the TDM Configuration menu (Configuration > Physical Port > E1 or T1),
configure the necessary parameters of the E1 or T1 services.
Defining a Pseudowire Peer
Configure a peer device which communicates with MiTOP-E1/T1 over a PW
connection.
³ To define the pseudowire peer:
• From the Peer menu (Configuration > Applications
> Multiservice over PSN >
Peer), define the IP and MAC addresses of the peer device.
Configuring a Pseudowire Connection
The E1/T1 traffic is encapsulated into a CESoPSN or SAToP PW and sent over
MPLS, UDP/IPv4 or Ethernet (MEF) networks.
³ To configure a pseudowire connection:
1. From the General Parameters menu (Configuration > Applications >
Multiservice over PSN > PW > General Parameters), set the source IP, PW
type, PSN type, In and Out PW labels.
2. From the PSN Parameters menu (Configuration > Applications > Multiservice
over PSN > PW > PSN Parameters), configure the PSN parameters.
3. From the Service Parameters menu (Configuration > Applications >
Multiservice over PSN > PW > Service Parameters), configure the payload size
and jitter buffer size for the PW.
4. From the PW menu (Configuration > Applications > Multiservice over PSN >
PW), enable the PW connection.