Specifications

MiTOP-E1/T1 Ver. 1.0 Installing MiTOP-E1/T1 1
Quick Start Guide
Installation of MiTOP-E1/T1 should be carried out only by an experienced
technician. If you are familiar with MiTOP-E1/T1, use this guide to prepare the
unit for operation.
1. Installing MiTOP-E1/T1
Configuring MiTOP-E1/T1 for First Use
Before accessing MiTOP-E1/T1 from the network, connect it to the SFP-CA
configuration module and assign an IP address to MiTOP-E1/T1 that complies with
your network requirements.
³ To configure MiTOP-E1/T1 for the first use:
1. Prepare your computer for connection to the SFP-CA configuration module.
2. Install the SFP-CA driver on the PC. The driver installation file, SFP-CA driver
for XP.exe, is accessed via the System on an SFP Family page on the Technical
Documentation CD.
3. Set MiTOP-E1/T1 to the Configuration mode via its DIP switches.
4. Connect the SFP-CA configuration device to the power using the DC adapter
supplied with the unit.
5. Plug MiTOP-E1/T1 into the SFP socket of SFP-CA configuration unit.
Reliable communication link between MiTOP-E1/T1 and SFP-CA is possible only
when the MiTOP-E1/T1 OAM parameter (Configuration > Applications >
Multiservice over PSN > PW > General Parameters) is set to Enable.
6. Connect SFP-CA to your PC via USB 2.0 port.
7. Access the MiTOP-E1/T1 management utility, using its default IP address
192.168.205.1, user name (su) and password (1234).
8. From the Host IP menu (Configuration > System > Management > Host IP),
enter the new IP address, the IP mask, and the default gateway values.
Installing MiTOP-E1/T1 into a Host Device
1. Configure MiTOP-E1/T1 for normal operation mode.
2. Insert MiTOP-E1/T1 into a free SFP (MSA-compatible) socket of the host
equipment.
3. Press MiTOP-E1/T1 firmly into the MSA SFP port connector.
MiTOP-E1/T1 is ready to operate.
Note