Specifications

Chapter 3 Configuration Instructions Installation and Operation Manual
3-24 Status Menu DXC-100PSX
Status Menu
-----------
Slot# Card Type Card Status Switch State Switch Status
----------------------------------------------------------------------------
01 Narrowband Redundant Ok Normal Ok
02 Narrowband Primary Ok Normal Ok
03 Narrowband Primary Ok Normal Ok
04 Narrowband Primary Ok Normal Ok
05 Narrowband Primary Ok Normal Ok
06 Broadband '2' Primary Ok Normal Ok
07 Broadband '2' Redundant Ok Normal Ok
08 Card Not Present Not Present Not Present Not Present
09 Card Not Present Not Present Not Present Not Present
10 Broadband '1' Primary Ok Normal Ok
11 Broadband '1' Redundant Ok Normal Ok
Power Supply A Status.: Fault Fan Maintenance: Auto Fan #01: Ok
Power Supply B Status.: Ok Fan Speed......: Low Fan #02: Ok
Chassis Temperature...: 85 F/29 C Fan #03: Ok
Figure 3-25. Protection Switch Status Menu
25. Place your cursor on the Fan Maintenance field and press <Enter>. Toggle
between the following options to change the fan’s speed:
 Auto
 Off
 Low
 Medium
 High.
As you toggle between options in the
Fan Maintenance field, the corresponding
option will appear in the
Fan Speed field (it will take approximately 2-3 seconds
for the corresponding option to appear). The only option that will not correspond
is the
Auto option. The Fan Maintenance field will indicate Auto while the Fan
Speed field will register either
Low, Medium or High . The speed setting is chosen
automatically by the controller card, with the setting dependent on the
temperature of the environment in which the Protection Switch is located.