Specifications

Chapter 3 Configuration Instructions Installation and Operation Manual
3-22 Status Menu DXC-100PSX
Table 3-5. DXC-100PSX Status Menu Field Descriptions
Field Description
Slot#: (display field) Displays the slot numbers in the N+1 Protection Switch, from 1 to 11 .
Card Type: (display field) Displays the type of card installed in the associated slot. It will be one of the
following:
•
Narrowband Redundant (slot 1 only)
•
Narrowband Primary (slots 2 to 11)
• Broadband '2' Primary (slots 1 to 6 only)
• Broadband '2' Redundant (slot 7 only)
•
Broadband '1' Primary (slots 8 to 10)
• Broadband '1' Redundant (slot 11 only)
• Card Not Present.
Card Status:
(display field)
Displays the status of the card in the DXC-100PSX. The status will either be Ok ,
Cable Missing or Not Present .
Switch State:
(display field)
Displays the state of the relay switch. The status will either be
Normal or
Switched .
Switch Status:
(display field)
Used to indicate if there is a discrepancy between the switchover command from
DSMC.2 and the position of the relay. The status will either be Ok , Not Present ,
protect slot xx , or Malfunction . If Malfunction is indicated, immediately contact
RAD Technical Support Department.
Power Supply A Status:
(display field)
Displays the status of Power Supply A in the N+1 Protection Switch. It will either
register
Ok or Fault .
Power Supply B Status:
(display field)
Displays the status of Power Supply B in the N+1 Protection Switch. It will either
register Ok or Fault .
Chassis Temperature:
(display field)
Displays the ambient temperature detected inside of the of the N+1 Protection
Switch and DXC-100.
Fan Maintenance:
(option field)
Sets the fan speed for the N+1 Protection Switch. The available settings are
Auto ,
Low , Medium , and High . When the N+1 Protection Switch unit powers up, the fan
speed default is
Auto . The fan speed is based on the temperature inside the N+1
Protection Switch, which is directly related to the surrounding temperature. When
the system is at Auto, the fan speed changes automatically depending upon room
temperature. When Auto is on, the fan settings are as follows:
•
Low - below 30 degrees C (86 degrees F)
• Medium - 30 degrees C (86 degrees F) to 40 degrees C (104 degrees F)
•
High - above 40 degrees C (104 degrees F)
You can also manually set the fan speed to
Off, Low, Medium or High .
Note: Taking the fan out of Auto mode is inadvisable.
Fan Speed: (display field) Displays the current fan speed as Off , Low , Medium , or High .
Fan #01, #02, #03:
(display field)
These fields display the status of each of the fans as either
Ok or Fault .