Specifications

Chapter 3 Configuration Instructions Installation and Operation Manual
3-8 Setting Up Multiple NDRGs DXC-100PSX
4. Go back to the DXC-100 Main Menu and select System Configuration , then
select
Slot Configuration . The following menu appears:
Nest #1 Slot Configuration Menu
Slot# Device Type Name Redundancy
----- ---------------- ------ ------------
1 Octal T1/E1 Disable
2 Octal T1/E1 Disable
3 Octal T1/E1 Disable
4 Octal T1/E1 Disable
5 Octal T1/E1 Disable
6 HDS-3 Disable
7 HDS-3 Disable
8 STS1 Disable
9 STS1 Disable
10 HDS-3 Disable
11 HDS-3 Disable
N+1 Redundancy Switchover: Automatic
N+1 Redundancy Restore: Manual
Change Card = [Enter key] [D]elete Card [P]ort/Link Cfg
Figure 3-8. Slot Configuration Menu
5. Position the cursor next to the slot you want to configure and press <Enter>.
The following menu appears:
Slot Configuration
Nest............: 1
Slot............: 1
Slot Name.......: New York
Card Type.......: Octal T1-E1
Redundancy...: Disable
Figure 3-9. Individual Slot Configuration Screen
6. Move your cursor to the Slot name field and press <Enter>, type in a slot
name, and press <Enter> again. In the above example,
New York is the named
slot.
7. Move your cursor to the
Card type field and press <Enter> to scroll through
the card options until the desired card appears. In the case of a Narrowband
Group, select
Octal T1/E1 (D8E1T1) .
8. Move your cursor to the
Redundancy field and press <Enter> until Enable is
displayed.