Specifications

Installation and Operation Manual Chapter 3 Configuration Instructions
DXC-100PSX Setting Up Multiple NDRGs 3-7
Configure a Narrowband Redundancy Group
1. From the DXC-100 Main Menu, select System Configuration , then select Nest
Profile
. The following menu appears:
Nest #1 : Profile
Nest name: Node Mgr. Unit I
Nest type:.............................: DXC-10011
Dual System Mgr........................: Yes
Alarm Contacts Type....................: Standard
Dual XCC...............................: Yes
Number of Rings for Modem Auto-Answer..: 2
Nest Dual Power Supplies...............: No
N+1 Redundancy Nest....................: Yes
Protection Switch Dual Power...........: No
N+1 Redundancy Narrowband Group........: Octal T1/E1
N+1 Redundancy Broadband Group 1.......: HDS-3
Protection Switch Dual Broadband Groups: Yes
N+1 Redundancy Broadband Group 2.......: HDS-3
Figure 3-7. The Nest Profile Menu
3. Carefully read each field on this menu, and set up your system based on your
equipment and software. To enable redundancy, select
Yes on the N+1
Redundancy Nest
field. Octal T1/E1 ( D8E1T1 ) will be the N+1 Redundancy
Narrowband Group
type, which is currently the only Narrowband Group type
available. Configure the Broadband Redundancy Group(s) as appropriate to
your application module configuration.