Specifications

Installation and Operation Manual Chapter 3 Configuration Instructions
DXC-100PSX Verifying Protection Switch Installation 3-3
Rev. 0 Controller Module cannot determine the chassis type. In order to enable a
second broadband group, go to the
Nest Profile Menu, which is displayed on the
following page. The information contained on the Protection Slot Information
Display is listed in
2 Table 3-1 .
Table 3-1. Protection Slot Information Display Field Descriptions
Field Description
Device: (display field) Displays the state of the DXC-100PSX as Online or Offline.
Psx Controller: (display field) Displays the revision level of the PSX Controller Module.
Chassis: (display field) Displays the type of chassis as DXC-100PSX.
Power Supply A or B:
(display field)
Displays the status of Power Supply A or B as one of the following:
• Ok
• Fault
Table 3-2. Protection Slot Information Display Field Descriptions
Field Description
Fan 1, 2, or 3: (display field) Displays the status of Fan 1, 2, or 3 as one of the following:
• Ok – Fan is operating properly.
• Fault – Fan has been shut off, or is otherwise inoperative.
DXC-100PSX Interface Card
Alarms: (display field)
Displays the status of each of the 11 slots in the DXC-100PSX.
Nest #1 : Profile
Nest name: Node Mgr. Unit I
Nest type:.............................: DXC-100
Dual System Mgr........................: No
Alarm Contacts Type....................: Standard
Dual XCC...............................: Yes
Number of Rings for Modem Auto-Answer..: 2
Nest Dual Power Supplies...............: No
N+1 Redundancy Nest....................: Yes
Protection Switch Dual Power...........: No
N+1 Redundancy Narrowband Group........: Octal T1/E1
N+1 Redundancy Broadband Group 1.......: HDS-3
Protection Switch Dual Broadband Groups: Yes
N+1 Redundancy Broadband Group 2.......: HDS-3
Figure 3-4. The Nest Profile Menu
Carefully read each field on this menu, and set up your system based on your
equipment and software. If you have redundancy, select
Yes on the N+1
Redundancy Node field. If you want to enable a second broadband group, select