Specifications

D8E1T1 Installation and Operation Manual Chapter 4 Troubleshooting and Diagnostics
Utilities Menu 4-31
Utilities Menu
----------------
************************************
* *
* -MESSAGE!- *
* *
* *
* Set device to Out Of Service? *
* *
* *
* Are you sure (Y/N)? *
* *
************************************
Figure 4-23. Board Status Screen (IS to OOS)
Press Y. The board is set to Out of Service, and you are returned to the Utilities
Menu. Press N, and you are returned to the Utilities Menu.
If the board status was Out of Service, the following prompt appears:
Utilities Menu
----------------
****************************************************
* *
* -MESSAGE!- *
* *
* *
* Set device to In Service? **Device Will Reset** *
* *
* *
* Are you sure (Y/N)? *
* *
****************************************************
Figure 4-24. Board Status Screen (OOS to IS)
Press Y. The module will be reset, the board will be set to In Service, and you are
returned to the Nest Summary Menu. Press N, and you are returned to the Utilities
Menu.
It can take up to 20 seconds for the Board Status to change to In Service. Once you
have been returned to the Slot Summary Menu, the D8E1T1 module’s state may
cycle through a combination of Online, Standby, Out of Service, and finally Online.
This is a normal occurrence when the device resets. Wait for the Device State on
the Slot Summary Menu to display Online before you proceed.
Note