Specifications

Chapter 4 Troubleshooting and Diagnostics D8E1T1 Installation and Operation Manual
4-30 Utilities Menu
Utilities Menu
----------------
************************************
* *
* -MESSAGE!- *
* *
* *
* Warm Reset Device? *
* *
* *
* Are you sure (Y/N)? *
* *
************************************
Figure 4-22. Warm Reset Device Prompt
2. Press Y to reset the board, and wait for the module to reset. This will take
approximately 15 seconds for a Warm Reset, after which you will be returned
to the Nest Summary Menu and the Device State will be displayed as Online.
Once you have been returned to the Nest Summary Menu, the D8E1T1 module’s
state will cycle through a combination of Standby, Out of Service, and Online. This
is a normal occurrence when the device resets. Wait for the Device State on the
menu to display Online before you proceed.
Board Status
The Board Status option allows the Administrator to put a device In Service or Out
of Service.
If a module is set to Out of Service, you cannot enter the Diagnostics Menu.
Navigation:
D8E1T1 Main Menu
↓
Utilities
↓
Board Status
If the board status was In Service, the following prompt appears:
Note
Note