Specifications

D8E1T1 Installation and Operation Manual Chapter 3 Configuration
Accessing the D8E1T1 Main Menu 3-9
3.4 Accessing the D8E1T1 Main Menu
The D8E1T1 Main Menu allows you to view the configuration of the D8E1T1
module, run diagnostic tests, access utilities, view N+1 Redundancy status
(DXC-100 units with N+1 Protection Switch), and display module identification
(software and hardware revision levels). These procedures are detailed on the next
several pages.
The procedure for accessing the Main Menu for a particular module set will be
different for the Standalone DXC-100 and stack versions. The Navigation Box below
shows the two different methods used to get to the Nest Summary Menu, from
which the module’s Main Menu and all subordinate menus can be accessed.
1. Use the appropriate method from the Navigation Box below to access the Nest
Summary Menu.
Navigation:
Standalone DXC-100
Main Menu
↓
Nest Summary
OR DXC-100 Stack
Main Menu
↓
Node Summary
↓
Nests Profile
↓
Nest with D8E1T1 Module
↓
Nest Summary
On the Nest Summary Menu, the Configured Type must display “Octal T1-E1” and
the Device State must display “Online” or “Standby” in order to access the D8E1T1
Main Menu. If the Device State is “Offline”, an alert message is generated.
Note
Note