Specifications

Chapter 3 Configuration D8E1T1 Installation and Operation Manual
3-4 D8E1T1 Module Configuration
Change a Module Set
1. Physically remove the module set from the DXC-100 unit.
2. Move your cursor to the slot where the module set resided, and press D. A
message appears stating, “
All existing connections for this slot
will be deleted.
” Press Y to confirm the action or N to cancel.
If you do not remove the module set prior to pressing D, the following message
appears: “
-ALERT!- Can not delete a device that is present”.
3. Physically insert the new module set into the DXC-100 unit in accordance with
Chapter 2.
4. Configure the slot for the new module set. Follow the steps in the previous
procedure.
A module set may also be changed without deleting the old module set by skipping
step 2 of this procedure.
3.3 D8E1T1 Module Configuration
This section will guide you through configuring the T1/E1 links for a D8E1T1
module.
A module does not have to be physically present to be configured, but the slot must
be configured for that type of module.
T1/E1 Link Configuration
Navigation:
Standalone DXC-100
Main Menu
↓
System Configuration
↓
Slot Configuration
↓
Select Slot with D8E1T1 Module
↓
[P]ort/Link Cfg
OR DXC-100 Stack
Main Menu
↓
System Configuration
↓
Nests Profile
↓
Select Nest with D8E1T1 Module
↓
[S]lot Conf.
↓
Select Slot with D8E1T1 Module
↓
[P]ort/Link Cfg
Note
Note
Note