Specifications

Chapter 3 Configuration D8E1T1 Installation and Operation Manual
3-2 Configure a Slot for a D8E1T1 Module
Node Configuration Menu
Slot Configuration
Nest Profile
System Clock Source Menu
Users Menu
Port IP Addresses
SNMP Agent Configuration
Date and Time
TACACS Plus
Figure 3-1. Node Configuration Menu
2. Place your cursor on the Slot Configuration field and press <Enter>. The
following menu appears, displaying slots numbered from 1 to 11.
For a DXC-100 stack, use the following sequence to reach the Slot Configuration
Menu (Figure 3-2): System Configuration
→ Nest Profile → Move your cursor to the
nest where the D8E1T1 module will reside
→ Press S.
Nest #1 Slot Configuration Menu
Slot# Device Type Name Redundancy
----- ---------------- ------ ------------
1 Octal T1/E1 Disable
2 Octal T1/E1 Disable
3 Octal T1/E1 Disable
4 Octal High Speed Disable
5 Octal High Speed Disable
6 Disable
7 HDS-3 Disable
8 HDS-3 Enable
9 T3 Disable
10 Octal T1-E1 Disable
11 HDS-3 Enable
N+1 Redundancy: Enable
N+1 Redundancy Switchover: Automatic
N+1 Redundancy Restore: Manual
Change Card = [Enter key] [D]elete Card [P]ort/Link Cfg
Figure 3-2. Slot Configuration Menu
3. Move your cursor to the slot number where the D8E1T1 module will reside,
and press <Enter>. The following menu appears:
Note