Specifications

Configure a Slot for a D8E1T1 Module 3-1

Chapter 3

Configuration

3.1 Introduction

This chapter provides specific configuration information for D8E1T1 modules. The

configuration activities are performed by means of the management system used

to control the DXC-100.

All the menus identify the D8E1T1 module as Octal T1/E1 or OT1E1.

This chapter covers only the configuration activities specific to D8E1T1 modules:

for general instructions and additional configuration procedures, refer to the

DXC-100 Installation and Operation Manual.

3.2 Configure a Slot for a D8E1T1 Module

In order to view the menus associated with the D8E1T1 module set, a slot must be

configured for the D8E1T1 module set, and a D8E1T1 Application Module must be

resident in the corresponding front slot in the DXC-100 equipment nest.

A D8E1T1 Interface Module must also be resident in the corresponding rear slot in

the nest. If the slot does not show a “Configured Type” in the Slot Summary Menu,

refer to the text below for information on how to configure a slot.

The following procedure describes how to assign and configure a slot for the

D8E1T1 module set.

1. From the DXC-100 Main Menu, move your cursor to the System Configuration

field and press <Enter>. The following menu appears:

Note