- Data Comm Router Owner Manual

31
AppleTalk Protocol
Required for AppleTalk
Frame Relay operation requires that the WAN port is set to be a “numbered
interface.” This means that the port (and thus the Frame Relay network) must have
an AppleTalk network number and the port must have an AppleTalk node number.
• AppleTalk numbered interface
• AppleTalk Network Number
• AppleTalk Node Number
RV: Use the WAN/AppleTalk screen.
CL: Use interface(misc) and then appletalk(set).
Suggested for AppleTalk
The settings above are all that is generally required for AppleTalk operation over
Frame Relay.
DECnet Protocol
Required for DECnet
Once DECnet has been turned on (a global setting discussed in the Ethernet section
above), no additional settings are generally required for DECnet operation over
Frame Relay.
Link Configuration
Frame Relay is presently supported in the BR Router only via dedicated line
operation.
• Set Dedicated connection
• Set Frame Relay connection
RV: Use the WAN/Link screen.
CL: Use interface(misc) and then wan mode(set).
Suggested for Dedicated/Leased Line Operation
Dedicated line operation generally does not require additional parameters for
operation.