Specifications

ASMi-52 Installation and Operation Manual Chapter 4 Managing ASMi-52 via a Terminal
Accessing the Remote ASMi-52 4-39
ASMi-52
Port local status
SHDSL (Standard ANNEX UNKNOWN, Wire mode 2W)
SHDSL Line (Status: NOT SYNC, State: IDLE mode)
Framer Type (SLOTTED T1)
EOC compatible (STANDARD)
Actual PSD (PSD UNKNOWN)
Line rate (not applicable)
T1 interface (IR-G704/BALANCE Data rate: 1536 kbps)
HW status (NO HARDWARE FAILURE)
Test status (NONE)>
(N)
ESC-prev.menu; !-main menu; &-exit;
Figure 4-42. Port Status Screen
The physical port alarms are described in Chapter 5.
4. Type N to display the next page.
4.8 Accessing the Remote ASMi-52
Accessing the remote ASMi-52 is performed using a virtual connection with your
terminal physically connected to the local unit.

To access the remote ASMi-52
1. From the Monitoring menu (Figure 4-40), select Open Virtual Connection
2. The Login screen of the second ASMi-52 appears.
3. Login to the second ASMi-52
You now have access to the second ASMi-52 menus.
If no key press is sensed for a period of 10 minutes, the virtual connection closes and
you are returned to the initial ASMi-52.

To close a virtual terminal
• From the Monitoring menu (of the second ASMi-52), select Close Virtual
Connection
The Main menu of the first ASMi-52 is displayed.
Note
Note