Specifications

Chapter 4 Managing ASMi-52 via a Terminal ASMi-52 Installation and Operation Manual
4-30 Configuring the Physical Ports
Configuring LLB/RLB Activation from the DTE

To enable/disable the LLB/RLB activation from the DTE:
1. From the Physical Ports Configuration menu, select DTE Configuration.
The DTE Configuration menu appears (see Figure 4-32).
2. Select DTE local port configuration to configure the local DTE port or select
DTE remote port configuration for the remote port configuration.
DTE Local/Remote Port Configuration menu appears (see Figure 4-33).
3. From the DTE Local/Remote Port Configuration menu, select LLB from DTE to
enable the LLB activation from the DTE or select RLB from DTE to enable the
RLB activation from the DTE.
The display is refreshed and a new value appears.
4. Select Save to save the changes.
ASMi-52
DTE configuration >
Port number: (1)
1. DTE local port configuration
2. DTE remote port configuration
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-32. DTE Configuration Menu
ASMi-52
DTE local port configuration >
1. LLB from DTE : (Disable)
2. RLB from DTE : (Disable)
3. Data rate > > (192 Kbps)
4. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-33. DTE Local Port Configuration Menu
Configuring the Data Rate
ASMi-52 supports multiple data rates in the range between 64 kbps and 4608 kbps,
depending on the clock mode and line/DTE interface of the local and remote units
(see Table 1-2 and Table 1-3).

To select the data rate:
1. From the DTE Port Configuration menu, select Data Rate.
The Data Rate menu appears (see Figure 4-34). The ASMi-52 screen in
Figure 4-34 is with a 2-wire, internal clock configuration.