Specifications

ASMi-52 Installation and Operation Manual Chapter 4 Managing ASMi-52 via a Terminal
Configuring ASMi-52 System Parameters 4-17
6. Select Save All to save the changes.
7. Press <Esc> to exit the editing mode.

To remove MAC address from the table:
1. From the Bridge Table, select MAC address that you intend to remove from the
static table.
2. Enter editing mode, as explained above.
3. Enter all zeros for the MAC address value and save the change.
ASMi-52
Bridge Table
Type (Static)
1. MAC Address ... (00000000000)
2. Port ... ()
>
ESC-prev.menu; !-main menu; &-exit; ?-help
Figure 4-20. Bridge Table, Editing Mode
Configuring Aging Timeout
The aging time is the timeout period in seconds for aging out dynamically learned
forwarding information. When the timeout period is over, the bridge removes all
inactive nodes from its database.

To configure aging timeout:
1. From the LAN Configuration menu, select Aging Timeout.
2. Enter a new aging timeout value in seconds and press <Enter>.
3. Select Save to save the change.
Setting the LAN Rate
When the LAN port of ASMi-52 is used for the DTE connection, the DTE rate is
configured via the LAN rate menu. The LAN rate depends on the rate mode (regular
or low speed, see Configuring Low Speed Operation above) and the line interface
(2-wire or 4-wire).
ASMi-52 units operating in the receive clock mode automatically detect LAN rate of
the central units and configure themselves accordingly.

To set the LAN rate:
1. From the LAN Configuration menu, select LAN Rate.
The LAN Rate menu appears (see Figure 4-21).
2. From the LAN Rate menu, select the desired data rate.
The LAN Configuration menu appears.
3. From the LAN Configuration menu, select Save to save the new value.
Note