Specifications

ASMi-52 Installation and Operation Manual Chapter 4 Managing ASMi-52 via a Terminal
Configuring ASMi-52 System Parameters 4-15
ASMi-52
Rem Agent Table
SOURCE IP DESTINATION IP PORT
172.17.161.30 255.255.255.255 DTS
172.17.161.34 224.0.0.9 DSL
172.17.161.182 224.0.0.9 DSL
172.17.160.104 172.17.161.186 DTS
>
ESC-prev.menu; !-main menu; &-exit; @-scroll; ?-help
Figure 4-17. Rem Agent Table
Configuring the LAN Port
ASMi-52 includes a 10/100BaseT port that can be used as a user or management
port. The LAN port operates in a self-learning bridge or transparent mode, with or
without autonegotiation.
If the LAN port serves as a management port only, it operates in transparent mode
with autonegotiation enabled.
Configuring LAN Port Operation Mode
In the transparent mode the LAN port operates with disabled filter, passing all
frames transparently. When operating as a self-learning bridge, the LAN port filters
the packets received from the local LAN and transfers through the link only frames
destined to another LAN.

To configure the LAN operation mode:
1. From the System Configuration menu, select LAN Configuration.
The LAN Configuration menu appears (see Figure 4-18).
2. From the LAN Configuration menu, select Operation Mode.
The Operation Mode menu appears.
3. From the Operation Mode menu, select Transparent to enable transparent
mode, or select Bridge to enable bridge mode.
Currently for the units with the serial, E1 or T1 DTE interfaces the Operation Mode is
permanently set to Transparent. For the modems with the 10/100BaseT user LAN
interface it is set to Bridge.
The LAN Configuration menu appears.
4. From the LAN Configuration menu, select Save to save your changes.
Note
Note