Specifications

Chapter 4 Managing ASMi-52 via a Terminal ASMi-52 Installation and Operation Manual
4-14 Configuring ASMi-52 System Parameters
ASMi-52
Management Access
1. SNMP allowed (access allowed)
2. TELNET allowed (access allowed)
3. WEB allowed (access allowed)
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-15. Management Access Menu
Configuring Dedicated Timeslots
ASMi-52 units with E1 or T1 port support management via a dedicated timeslot.
A remote E1 device can be managed via DTS if the DTS mode is enabled in both
the CO unit and the CPE unit. The MNG timeslot is transferred over the SHDSL to
the E1 CPE, the CPE forwards the MNG timeslot over the E1 line to the next device
in the chain.
Allocate the same timeslot number for MNG in all devices in the chain. With DTS
mode enabled in all devices, then the chain can be managed remotely from one NMS.
In T1 systems, the DTS is manages the local unit only, it is not forwarded over SHDSL.

To configure dedicated timeslots:
1. From the Management menu, select DTS Configuration.
The DTS Configuration menu is displayed (see Figure 4-16).
2. From the DTS Configuration menu, configure the dedicated timeslot in the
following order:
 Assign DTS IP address
 Assign DTS IP mask
 Enable DTS mode.
3. Check the status of the DTS configuration in the Rem Agent Table (see Figure 4-17).
4. From the Management menu, select Save to save the changes.
In the Map Timeslot menu (Figure 4-38), the dedicated timeslot value
changes to MNG (management).
ASMi-52
DTS Configuration
1. DTS Mode (Enable)
2. DTS IP Address (1.1.1.1)
3. DTS IP Mask (255.255.255.0)
4. Rem Agent Table []>
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-16. DTS Configuration Menu
Note