Specifications

ASMi-52 Installation and Operation Manual Chapter 3 Operation
Default Settings 3-5
Table 3-4. Default Settings (Cont.)
Parameter Default Value
SHDSL Interface
Transmission mode Annex B
Power backoff Enable
Snext margin Disable
Current margin Disable
Asym PSD Symmetrical
Line prob Fixed rate
Note: ASMi-52 units with 4-wire line interface support only fixed rate.
Configured wire 4w
Loop attenuation threshold 0
SNR margin threshold 0
Serial DTE Interface
Rate ASMi-52, 2-wire and V.35 – 192 kbps
ASMi-52, 4-wire and V.35 – 384 kbps
LLB from DTE Disable
RLB from DTE Disable
E1 Interface
Framed mode Unframed
Sync CCITT
CRC-4 No
Idle Code ff
Units identical settings Yes
T1 Interface
Framed mode Unframed
Line code B8ZS
Receive gain Long
Interface DSU
Transmit signal mask 0 feet
Fbit configuration Transparent
Sync mode Fast (after 1 sec)
Idle code ff
Units identical set Yes