Specifications

ASMi-52 Installation and Operation Manual Chapter 3 Operation
Default Settings 3-3
Normal Indications
Upon turning on ASMi-52, the PWR LED in the front panel lights to indicate that
ASMi-52 is on. Table 3-3 shows the correct status of the indicators a few seconds
after the units were synchronized.
Table 3-3. ASMi-52 Indicator Status
Indicator Status
PWR ON
TST OFF
ALM OFF
SYNC ON (green)
If the above LED indications do not appear following initial power turn-on, refer to
Chapter 5 for the diagnostic test instructions.
Turning Off ASMi-52

To turn off ASMi-52:
• Remove the power cord from the power source.
3.3 Default Settings
ASMi-52 is managed by an ASCII terminal or PC running a terminal emulation
program via menu-driven embedded software. Table 3-4 lists the default settings of
the ASMi-52 configuration parameters.
Table 3-4. Default Settings
Parameter Default Value
System
Clock Internal
Sys contact –
Sys location –
Sys name –
Host IP address 0.0.0.0
Host IP mask 0.0.0.0
Host default gateway 0.0.0.0
Read community public
Write community public
Trap community public
SNMP allowed Access allowed