Specifications

ASMi-52 Installation and Operation Manual Chapter 1 Introduction
Overview 1-5
Timing
ASMi-52 supports three clock modes:
• Internal, derived from its internal oscillator (CO mode)
• External, supplied by the attached DTE
• Receive, recovered from the received line signal (CPE mode).
Management
ASMi-52 supports the following management options:
• SLIP via V.24 (RS-232) terminal port
• Telnet via dedicated 10/100BaseT port
• SNMP network management (RADview) via dedicated 10/100BaseT port
• PC, running a Web browsing application (ConfiguRAD)
• Inband management via dedicated timeslot (units with E1/T1 interface only).
EOC
ASMi-52 provides an inband management channel (EOC) for end-to-end system
management and supervision. This management channel uses SHDSL overhead
bits and operates without interfering with data transmission.
ConfiguRAD
ConfiguRAD is user-friendly Web-based terminal management system serving for
remote device configuration and maintenance. It is embedded in ASMi-52 and
provided at no extra cost. ConfiguRAD can be run from any standard Web
browser.
Dial-In
The V.24 terminal port supports dial-up modem connection for remote
management of ASMi-52 over telephone lines.
Dial-Out
The V.24 terminal port supports alarm dial-out.