Specifications

ASMi-52 Installation and Operation Manual Appendix B IR-IP Interface Module
Erasing IR-IP Software B-29
• When you cannot configure IR-IP because its current LAN-interface IP address
and/or the Telnet password, are not known.

To erase the user’s configuration:
1. Turn ASMi-52 off.
2. Set all the four sections of the IR-IP DIP switch (see Table B-2) to ON.
3. Turn ASMi-52 on and monitor the ERR and LINK indicators: they must blink
alternately.
4. While ERR and LINK are blinking (within 15 seconds), set sections 1 and 2 of
the DIP switch to OFF.
The IP router configuration is erased. During the process of erasing, the
ERR indicator turns on and lights steadily.
If you do not set sections 1 and 2 to OFF within 15 seconds of power-up, the IP
router card ignores the setting of all the four sections to ON and starts normal
operation. In this case, it is recommended to turn ASMi-52 off and then back on.
To abort the whole operation, turn ASMi-52 off, return all the four-switch section to
the desired positions, and then turn ASMi-52 on again.
5. Turn ASMi-52 off, and then return all the four sections of the DIP switch to the
desired positions.
B.14 Erasing IR-IP Software
You may erase the IR-IP application software, without erasing the user-defined
parameters.
After the application software is erased, IR-IP starts its TFTP server application, and
waits for the downloading of software by a TFTP client connected to its LAN
interface. The procedure to be used to download the application software in this
case is also described below.
You may want to erase the application software if the downloading of new
software using the Device Control menu (see Figure B-15) fails, and the IP router
card does not function properly.
Erasing Application Software

To erase the application software:
1. Turn ASMi-52 off.
2. Set all the four sections of IR-IP DIP switch to ON.
3. Turn ASMi-52 on and monitor the ERR and LINK indicators: they must blink
alternately.
4. While ERR and LINK are blinking (within 15 seconds), set sections 3 and 4 of
the DIP switch to OFF.
The IP router application software is erased. During the process of erasing,
the ERR indicator turns on and lights steadily.
Note